Archive for February, 2012

CCNP 642-902 EXAM 8

Question 1 Refer to the exhibit. You are the network administrator responsible for the NProuter, the 10.1.1.1 router, and the 10.1.1.2 router. What can you determine about the OSPF operations from the debug output?

February 9, 2012 · admin · No Comments
Tags: ,  · Posted in: CCNP

CCNP 642-902 EXAM 7

Question 1 Into which two types of areas would an area border router (ABR) inject a default route? (Choose two) A. the autonomous system of a different interior gateway protocol (IGP) B. area 0 C. totally stubby D. NSSA E. stub F. the autonomous system of an exterior gateway protocol (EGP) Answer: C E

February 9, 2012 · admin · No Comments
Tags: ,  · Posted in: CCNP

CCNP 642-902 EXAM 6

OSPF Questions Question 1 An administrator Pipes in the command router ospf 1 and receives the error message: “OSPF process 1 cannot start.” (Output is omitted.) What should be done to correctly set up OSPF? A – Ensure that an interface has been configured with an IP address

February 9, 2012 · admin · No Comments
Tags: ,  · Posted in: CCNP

EIGRP – SHOW IP EIGRP TOPOLOGY ALL-LINKS

EIGRP – SHOW IP EIGRP TOPOLOGY ALL-LINKS Question Refer to the exhibit. BigBids Incorporated is a worldwide auction provider. The network uses EIGRP as its routing protocol throughout the corporation. The network administrator does not understand the convergence of EIGRP. Using the output of the show ip eigrp topology all-linkscommand, answer the administrator’s questions.

February 9, 2012 · admin · No Comments
Tags: ,  · Posted in: CCNP

CCNP 642-902 EXAM 5

EIGRP Questions Question 1 Which three descriptions are correct based on the exhibited output? (Choose three) A. R1 is configured with the variance command. B. The route to 10.2.0.0/16 was redistributed into EIGRP. C. A default route has been redistributed into the EIGRP autonomous system. D. R1 is configured with the ip summary-address command.

February 8, 2012 · admin · No Comments
Tags: ,  · Posted in: CCNP